Chrysler 1997 Stratus Convertible RHD Service Manual page 43

CALIPER STEERING KNUCKLE GUIDE PIN BOLTS SPRING WASHER ASSEMBLY FRONT H UB
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 39 Cotter Pin, Nut Lock
Fig. 40 Loosening Front Hub Nut
the required lifting procedure to be used for this
vehicle.
(4) Remove front tire and wheel assembly from the
hub.
(5) Remove front disc brake caliper to steering
knuckle guide pin attaching bolts (Fig. 41).
Fig. 41 Front Disc Brake Caliper Mounting
DISC BRAKE CALI- COTTER PIN PER ASSEMBLY NUT LOCK
HUB NUT
DISC BRAKE CALI- LIFT THIS END OF CALIPER AWAY PER ASSEMBLY WIRE HANGER ROTOR FROM KNUCKLE FIRST DISC BRAKE CALI- STEERING PER ASSEMBLY
(6) Remove disc brake caliper assembly from steer-
ing knuckle. Caliper is removed by first lifting bot-
tom of caliper away from steering knuckle, and then
removing top of caliper out from under steering
knuckle (Fig. 42).
Fig. 42 Disc Brake Caliper Removal
(7) Support brake caliper/adapter assembly using a
wire hook (Fig. 43) and not by hydraulic hose.
Fig. 43 Correctly Supported Front Disc Brake
(8) Remove the braking disc from the front hub/
bearing assembly.
(9) Remove nut attaching outer tie rod end to the
steering knuckle (Fig. 44). Nut is to be removed
from tie rod end using the following procedure,
hold tie rod end stud with a 11/32 socket while
loosening and removing nut with wrench (Fig.
44).
(10) Remove the tie rod end from the steering
knuckle using Remover, Special Tool MB-991113 (Fig.
45).
(11) Remove the
bracket (Fig. 46) from the steering knuckle.
UPPER CONTROL ARM STEERING KNUCKLE STEERING
ABS SPEED SEN-
SUSPENSION
Caliper
speed sensor cable
KNUCKLE BRAKE SHOE OUTBOARD ROTOR
SOR CABLE
2 - 21
routing