Chrysler 1997 Stratus Convertible RHD Service Manual page 53

DISC ASSEMBLY (STORED) STEERING KNUCKLE BRAKE CALIPER
DISC BRAKE CALI- LIFT THIS END OF CALIPER AWAY PER ASSEMBLY WIRE HANGER ROTOR BRAKING DISC FROM KNUCKLE FIRST DISC BRAKE CALI- STEERING PER ASSEMBLY
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 79 Brake Caliper Removal
Fig. 80 Supporting Brake Caliper
Fig. 81 Removing/Installing Front Braking Disc
Special Tool C-4150 on hub and bearing assembly
flange and wheel stud (Fig. 82).
(8) Tighten down on special tool, this will push the
wheel stud out of the hub and bearing flange.
UPPER CONTROL ARM STEERING KNUCKLE STEERING KNUCKLE BRAKE SHOE OUTBOARD
ABS SPEED SEN-
ROTOR STEERING KNUCKLE WHEEL STUD FRONT HUB
SOR CABLE
Fig. 82 Removing Wheel Stud From Hub And
INSTALL
(1) Install replacement wheel stud into flange of
hub and bearing assembly. Install washers on wheel
stud, then install a wheel lug nut on stud with flat
side of lug nut against washers (Fig. 83).
Fig. 83 Installing Wheel Stud Into Hub
(2) Tighten the wheel lug nut, pulling the wheel
stud into the flange of the hub and bearing assembly.
When the head of the stud is fully seated against the
bearing flange, remove lug nut and washers from
wheel stud.
(3) Install the rotor back on the front hub/bearing
(Fig. 81).
(4) Install disc brake caliper assembly on steering
knuckle. Caliper is installed by first sliding top of
caliper under top abutment on steering knuckle.
Then installing bottom of caliper against bottom
abutment of steering knuckle (Fig. 84).
(5) Install disc brake caliper assembly attaching
bolts (Fig. 78) and torque to 31 N·m (23 ft. lbs.).
WASHERS STEERING KNUCKLE LUG NUT FRONT HUB SPECIAL WHEEL
SUSPENSION
Bearing
C-4150A TOOL NUT LUG
2 - 31