Chrysler 1997 Stratus Convertible RHD Service Manual page 48

SPRING WASHER FRONT H UB
2 - 26 SUSPENSION
REMOVAL AND INSTALLATION (Continued)
Fig. 58 Cotter Pin, Nut Lock
Fig. 59 Loosening Front Hub Nut
cation and Maintenance section of this manual, for
the required lifting procedure to be used for this
vehicle.
(4) Remove front tire and wheel assembly from the
hub.
(5) Remove front disc brake caliper to steering
knuckle guide pin attaching bolts (Fig. 60).
(6) Remove disc brake caliper assembly from steer-
ing knuckle. Caliper is removed by first lifting bot-
tom of caliper away from steering knuckle, and then
removing top of caliper out from under steering
knuckle (Fig. 61).
(7) Support brake caliper/adapter assembly using a
wire hook (Fig. 62) and not by hydraulic hose.
(8) Remove the braking disc from the front hub/
bearing assembly (Fig. 63).
(9) Remove nut attaching the outer tie rod end to
the steering knuckle (Fig. 64). Nut is to be
removed from tie rod end using the following
procedure, hold tie rod end stud with a 11/32
socket while loosening and removing nut with
wrench (Fig. 64).
COTTER PIN NUT LOCK
HUB NUT
DISC BRAKE CALI- CALIPER STEERING AWAY LIFT THIS END OF CALIPER WIRE HANGER PER ASSEMBLY ROTOR KNUCKLE GUIDE PIN BOLTS FROM ASSEMBLY KNUCKLE FIRST DISC BRAKE CALI- STEERING PER ASSEMBLY
Fig. 60 Front Disc Brake Caliper Mounting
Fig. 61 Caliper Removal From Steering Knuckle
Fig. 62 Correctly Supported Front Disc Brake
(10) Remove the tie rod end from the steering
knuckle arm, using Remover, Special Tool MB-991113
(Fig. 65).
UPPER CONTROL ARM STEERING KNUCKLE DISC BRAKE CALI- PER ASSEMBLY STEERING KNUCKLE
ABS SPEED SEN-
Caliper
BRAKE SHOE OUTBOARD ROTOR
SOR CABLE
JX