Chrysler 1997 Stratus Convertible RHD Service Manual page 95

STEERING BRAKE CALIPER FLEX LOWER HEAT SHIELD WHEEL SPEED SEN- KNUCKLE TIE END STUD SOR CABLE CONTROL ROD ARM SPEED HOSE CASTLENUT TIE ROD END SENSOR
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 17 Lower Ball Joint to Steering Knuckle
Attachment
Fig. 18 Wheel Speed Sensor Cable Routing Bracket
Fig. 19 Installing Tie Rod End Nut
Then installing bottom of caliper against bottom
abutment of steering knuckle (Fig. 21).
CABLE BRACKET ROUTING NUT COTTER PIN ATTACHINGBOLT BALL JOINT STUD STEERING STEERING KNUCKLE KNUCKLE CALIPER STEERING AWAY LIFT THIS END OF CALIPER ROTOR KNUCKLE GUIDE PIN BOLTS FROM ASSEMBLY KNUCKLE FIRST DISC BRAKE CALI- HEAT SHIELD STEERING PER ASSEMBLY CROWFOOT
DIFFERENTIAL AND DRIVELINE
Fig. 20 Torquing Tie Rod End Nut
Fig. 21 Disc Brake Caliper Assembly Installation
(12) Install caliper assembly to steering knuckle
guide pin bolts (Fig. 22). Tighten caliper assembly
bolts to 31 N·m (23 ft. lbs.).
Fig. 22 Disc Brake Caliper Bolts
11/32 SOCKET STEERING KNUCKLE DISC BRAKE CALI- STEERING KNUCKLE PER ASSEMBLY TORQUE BRAKE SHOE OUTBOARD WRENCH
TIE ROD END
3 - 7