Chrysler 1997 Stratus Convertible RHD Service Manual page 210

LEFT REAR SIDE VIEW FWD
7 - 24 COOLING SYSTEM
REMOVAL AND INSTALLATION (Continued)
ENGINE BLOCK HEATER
REMOVAL
(1) Drain coolant from radiator and cylinder block.
Refer to Cooling System Drain, Clean, Flush and
Refill of this section for procedure.
(2) Detach power cord plug from heater.
(3) Loosen screw in center of heater. Remove
heater assembly.
INSTALLATION
(1) Thoroughly clean core hole and heater seat
(Fig. 35).
(2) Insert heater assembly with electrical connec-
tor position at the top of the core hole.
(3) With heater seated, tighten center screw
securely to assure a positive seal.
(4) Fill cooling system with coolant to the proper
level, vent air, and inspect for leaks. Pressurize sys-
tem with Radiator Pressure Tool before looking for
leaks.
The power cord must be secured in its retainer
clips, and not positioned so it could contact linkages
or exhaust manifolds and become damaged.
2.5L ENGINE BLOCK HEATER F WD
Fig. 35 Engine Block Heaters
BLOCK HEATER RIGHT REAR SIDE VIEW LEFT REAR
GENERATOR, POWER STEERING PUMP AND AIR
CONDITIONING COMPRESSOR DRIVE BELT—2.4L
CRANKSHAFT POWER DAMPER STEERING PUMP
ENGINE
AIR CONDITIONING COMPRESSOR AND
GENERATOR BELT
Accessory Drive Belt System—All Engines
SIDE FWD 2.4L ENGINE 2.0L ENGINE
VIEW
AIR CONDITIONING COMPRESSOR
JX
GENERATOR IDLER