Chrysler 1997 Stratus Convertible RHD Service Manual page 141

AIR CHAM- BER ATTACHINGBOLT INTAKE MANIFOLD PCV HOSE
LEFT STRUT TOWER
JX
REMOVAL AND INSTALLATION (Continued)
(2) Correctly isolate remote ground cable when ser-
vicing vehicle by installing the ground cable insulator
on the strut tower ground stud as shown (Fig. 102).
This will prevent accidental grounding of the
remote ground cable.
Fig. 102 Correctly Isolated Remote Ground Cable
(3) Remove the PCV hose (Fig. 103) from the air
chamber located on the front of the intake manifold.
Remove bolt (Fig. 103) attaching the air chamber to
the intake manifold. Then unlatch lid of air cleaner
from air cleaner housing and loosen clamp attaching
air inlet hose to throttle body (Fig. 103). Remove the
air cleaner lid, air inlet hose and air chamber (Fig.
103) as an assembly from the engine.
Fig. 103 Engine Air Intake System Components
THROTTLE BODY AIR AIR GROUNDSTUD HOSE INLET CLEANER HOUSING
AIR CLEANER LID
(4) Remove the throttle cable and if equipped the
speed control cable from the throttle body (Fig. 104).
Remove the vacuum hose (Fig. 104) from the throttle
body. Remove the wiring harness connectors from EGR VALVE INTAKE MANI- ELECTRICAL THROTTLE CONNECTORS FOLD POSITION VACUUMHOSE SENSOR INTAKE THROTTLE BODY MOUNT- MOUNTING BOLTS MANI- FOLD
AIS motor and the Throttle Position Sensor (Fig.
104) on the throttle body. Then, remove the 4 bolts
(Fig. 104) attaching the throttle body to the intake
manifold and remove it from intake manifold.
Fig. 104 Throttle Body Attachment To Intake
(5) Without removing cables from bracket, remove
the throttle and speed control cable mounting
bracket (Fig. 104) from the intake manifold.
(6) Remove the EGR tube (Fig. 105) from the
intake manifold and EGR valve.
Fig. 105 EGR Tube Attachment To Intake Manifold
And EGR Valve
BRAKES
THROTTLE ING BOLTS BODY AIS MOTOR EGR SPEED ASSEMBLY TUBE THROTTLE CABLE ELECTRICAL CONTROL MOUNTING BOLTS CONNECTOR
Manifold
5 - 39
CABLE BRACKET AND