Chrysler 1997 Stratus Convertible RHD Service Manual page 142

5 - 40 BRAKES
REMOVAL AND INSTALLATION (Continued)
(7) If equipped, remove the vehicle's wiring har-
ness connector from the speed control servo. Remove MOUNTING NUTS
the 2 speed control servo mounting bracket to strut
tower attaching nuts (Fig. 106). Without removing
speed control cable from servo, move speed control
CYLINDER MASTER ASSEMBLY
servo out of the way.
Fig. 106 Speed Control Servo Attachment To Strut
(8) Remove the wiring harness connector from the
brake fluid level sensor in the master cylinder fluid
reservoir (Fig. 107).
Fig. 107 Master Cylinder Brake Fluid Level Sensor
(9) Remove the primary and secondary brake
tubes (Fig. 108) or (Fig. 109) from the master cylin-
der.
(10) Remove the 2 nuts (Fig. 110) attaching the
master cylinder assembly to the power brake vacuum
booster.
CAUTION: When removing the routing clip and
brake tubes from the mounting stud do not bend or
kink the chassis brake line tubes.
SPEED CONTROL SERVO STRUT TOWER AIR CLEANER
BRAKE TUBES MASTER CYLINDER FLUID LEVEL SENSOR
LEFT SHOCK
TOWER
Tower
BRAKE VACUUM BOOSTER BRAKE FLUID RESERVOIR MASTER CYLINDER MOUNTING NUTS ROUTING CLIP
MASTER DER FLUID RES- ERVOIR CYLIN- MASTER CYLINDER SEC- ONDARY PORTS
MASTER CYLINDER PRI-
Fig. 108 Primary And Secondary Brake Tubes With
Antilock Brakes
Fig. 109 Primary And Secondary Brake Tubes
Without Antilock Brakes
Fig. 110 Master Cylinder Mounting To Vacuum
Booster
MARY PORTS
JX
CYL- I NDER MASTER