Chrysler 1997 Stratus Convertible RHD Service Manual page 92

DISC BRAKE CALI- CALIPER STEERING AWAY LIFT THIS END OF CALIPER WIRE HANGER PER ASSEMBLY ROTOR KNUCKLE GUIDE PIN BOLTS FROM ASSEMBLY KNUCKLE FIRST DISC BRAKE CALI- STEERING PER ASSEMBLY
3 - 4 DIFFERENTIAL AND DRIVELINE
REMOVAL AND INSTALLATION (Continued)
Fig. 4 Caliper Guide Pin Attaching Bolts
Fig. 5 Removing Disc Brake Caliper
Fig. 6 Correctly Supported Brake Caliper
(10) Remove the tie rod end stud from steering
knuckle arm, using remover, Special Tool MB-991113
(Fig. 8).
UPPER CONTROL ARM STEERING KNUCKLE DISC BRAKE CALI- PER ASSEMBLY STEERING KNUCKLE BRAKE SHOE OUTBOARD
ABS SPEED SEN-
ROTOR STEERING HEAT SHIELD KNUCKLE TIE END STUD ROD
SOR CABLE
Fig. 7 Removing Tie Rod End Attaching Nut
BRAKE CALIPER FLEX WHEEL SPEED SEN- SOR CABLE SPEED HOSE
Fig. 8 Tie Rod End Removal from Steering Knuckle
(11) If equipped with antilock brakes, remove the
speed sensor cable routing bracket from the steering
knuckle (Fig. 9).
Fig. 9 Wheel Speed Sensor Cable Routing Bracket
TIE ROD END NUT
SENSOR CABLE BRACKET ROUTING
JX
ATTACHINGBOLT STEERING KNUCKLE