Meter Click Charge - Ricoh G-P3 Service Manual

1. Installation Procedure
7. Press the "Menu" key to return to the initial screen.
Printing the Test Page
1
1. You can check if the printer works correctly by printing a test page such as the configuration page.
However, you cannot check the connection between the printer and the computer by printing the test
page.
2. Turn on the power switch of the printer.
• "Ready" shows on the panel display after the machine warms up.
3. Press the "Menu" key.
4. Press the "" or "" key to select "List/Test Print."
5. Press the "OK" key.
6. Press the "" or "" key to select "Config. Page".
7. Press the "OK" key.
8. The test printing starts shortly after.
9. Press the "Menu" key to return to the initial screen.
10. Turn off the power switch of the printer.
Settings Relevant to the Service Contract
Change the necessary settings depending on the each customer's service contract. For details, refer to
"Meter Click Charge" following this section.

Meter Click Charge

Basically, there are two ways to set up this function.
Meter click change enabled (SP 5-930-001 set to 'enabled'): The counter can be displayed and printed
by the customer. The technician can then call the customer and ask them to read the counter.
Meter click charge disabled (SP 5-930-001 set to 'disabled'; this is the default setting): The counter cannot
be displayed or printed by the customer. To check the counter, the technician must print the SMC report
(SP 5-990).
• You must select one of the counter methods (developments/prints) in accordance with the contract
(* SP5-045-001).
28