Ricoh G-P3 Service Manual page 164

1911 026 Duplex Temp. 2
1911 027 Duplex Temp.: S1
1911 028 Duplex Temp.: S2
1911 029 Duplex Temp.: S3
1911 040 Dec.Tmp Keep Time
[Fusing Rotat.] Fusing Unit Roller Rotation Control
1912
Paper Type -> TC1: Thick paper 1, TC2: Thick paper 2, OHP, SP: Special, GL: Glossy
paper
Rotation
When the printer is in the ready condition, the nip between the hot roller and pressure
1912 001
roller is in the same position. This may cause deformation of the rollers. Therefore, a
temporary rotation prevents this problem. SP 1912 001 turns this feature on or off.
SP1912-003 and 004 control this rotation.
Pre-rotation: Fusing idling
Prerotat. Speed
1912 002
Adjusts the speed of the fusing-unit rollers during fusing idling.
0: Regular speed, 1: Low speed, 2: 1/3 regular speed
Rotation Freque.
1912 003
Adjusts the frequency of the fusing-unit roller rotation if the machine is in the ready
condition for a very long interval.
Rotation Inter.
1912 004
*EGB [0 to 200 / 5 / 1deg /step]]
This SP keeps the target print temperature for
specified printouts with this SP in duplex printing.
*EGB
[0 to 500 / 80 / 1 sheet/step]
This SP controls when the temperature reduction of
SP1911-025 is done.
*EGB
[0 to 500 / 10 / 1 sheet/step]
This SP controls when the temperature reduction of
SP1911-026 is done.
*EGB
[0 to 500 / 15 / 1 sheet/step]
Keeps the temperature reduction for the time
specified with this SP even the process control
*EGB
interrupts the multiple printing job.
[0 to 500 / 60 / 1 sec/step]
[0 or 1 / 1 / -]
*EGB
0: Off 1: On.
*EGB [0 to 2 / 2 / -]
*EGB [1 to 24 / 4 / 1 hour/step]
*EGB [0 to 25 / 0.1 / 0.1 sec/step]
Service Mode Table
5
163