Ricoh G-P3 Service Manual page 119

4. Troubleshooting
SC
[Level]
The USB interface cannot be
[B]
used due to a driver error.
HDD: Initialization error
860
4
The controller detects that the
[B]
hard disk fails.
HDD: Reboot error
The HDD does not become
861
ready within 30 seconds after
[D]
the power is supplied to the
HDD.
HDD: Read error
863
The data stored in the HDD
[D]
cannot be read correctly.
HDD: CRC error
864
While reading data from the
[D]
HDD or storing data in the
HDD, data transmission fails.
HDD: Access error
865
118
Symptom
• Defective USB driver
• Loose connection
1. Check the connection.
2. Replace the controller.
• HDD not initialized
• Defective HDD
1. Reformat the HDD (SP5832).
2. Replace the HDD.
• Loose connection
• Defective cables
• Defective HDD
• Defective controller
1. Check the connection between the HDD and
2. Check and replace the cables.
3. Replace the HDD.
4. Replace the controller.
• Defective HDD
• Defective controller
1. Replace the HDD.
2. Replace the controller.
• Defective HDD
1. Replace the HDD.
Possible Cause/Required Action
controller.