Ricoh G-P3 Service Manual page 141

5. Service Tables
Mode
OHP/Thick
4. Count Unit
R: Rotation
S: Prints
5. Environment
LL: Low temperature and Low humidity
ML: Medium temperature and Low humidity
5
MM: Medium temperature and Medium humidity
MH: Medium temperature and High humidity
HH: High temperature and High humidity
7. Others
The following symbols are used in the SP mode tables.
FA: Factory setting (Data may be adjusted from the default setting at the factory.)
DFU: Design/Factory Use only - Do not touch the SP mode in the field.
"P" in the right hand side of the mode number column means that this SP mode relates to the Printer
Controller. If "P" is not in the column, this SP mode relates to the Printer Engine.
A sharp (#) to the right hand side of the mode number column means that the main switch must be turned
off and on to effect the setting change.
An asterisk (*) to the right hand side of the mode number column means that this mode is stored in the
NVRAM (Engine and Printer Controller). If you do a RAM clear, this SP mode will be reset to the default
value. "EGB", "CTL" and "NV" indicate which NVRAM contains the data.
• EGB: NVRAM on the EGB board
• CTL: NVRAM on the controller board
• NV: NVRAM on the NVRAM expansion board (user account enhancement kit)
The settings of each SP mode are explained in the right-hand column of the SP table in the following manner.
[ Adjustable range / Default setting / Step ] Alphanumeric
• If "Alphanumeric" is written to the right of the bracket as shown above, the setting of the SP mode is
displayed on the screen using alphanumeric characters instead of only numbers. However, the settings
in the bracket in the SP mode table are explained by using only the numbers.
140
Resolution (dpi)
600 x 600
1,200 x 600
1,200 x 1,200
Line speed (mm/s)
91
Print speed (ppm)
15