Ricoh G-P3 Service Manual page 89

3. Replacement and Adjustment
• Those saved in the previous adjustment: Controller SP 1101 ToneCtlSet - Tone (Prev)
• The factory settings: Controller SP 1101 ToneCtlSet - Tone (Factory).
Adjustment Procedure
1. Enter the controller service mode.
2. Use the down arrow key to select Controller SP 1102 "ToneCtlSet". Then press the Enter key.
3. Use the up/down key to select the mode you want to calibrate, Then press the Escape key until you
3
get back to the controller service mode menu.
4. Use the down arrow key to select Controller SP 1103 "PrnColorSheet". Then press the Enter key.
5. Use the up/down key to select Controller SP 1103 001 "ToneCtlSheet" (normally this is displayed
by default). Then press the Enter key.
6. When "Execute?" shows, press the Enter key to print out the "color calibration test sheet".
7. Press the Escape key 2 times to exit from the menu when "Execute OK" shows. (You return to Controller
SP 1103 "PrnColorSheet" in the controller service menu.)
8. Use the down arrow key to select Controller SP 1104 "ToneCtlValue". Then press the enter key.
9. Use the up/down arrow key to select the setting you want to adjust. Then press the enter key. The
three digits in the display (example '016') indicate a position on the color calibration test sheet.
Adjust the color density at each of the 15 points for each of the four colors.
88
Operation Panel Display
Set Black 1
Set Black 2
Set Black 3
:
:
Set Black 13
Set Black 14
Set Black 15
Set Cyan 1 to 15
Set Magenta 1 to 15
Set Yellow 1 to 15
Color Calibration Test Sheet
Default Value 16
Default Value 32
Default Value 48
:
:
Default Value 208
Default Value 224
Default Value 240
See Set Black 1 to 15
See Set Black 1 to 15
See Set Black 1 to 15