Ricoh G-P3 Service Manual page 329

5. Service Tables
5
When you save the firmware, we recommend that you arrange folders and files as follows:
• In the folder romdata, make only one folder and use this folder for one model. Use the machine code
as the name of this folder.
• When you save some files other than firmware, make a new folder outside romdata. Save the files in
this folder. Do not save any file outside the folders. (The diagram shows an example. Three folders,
log, nvramdata, and prt, are outside romdata. These folders can store debug logs, NVRAM data,
and captured files respectively.)
Update Procedure
1. Turn off the main power switch.
2. Disconnect the printer from the network.
3. Remove the slot cover from slot 2 ( x 1).
• Do not use slot 1. Slot 1 is for customer use.
4. Turn the SD card face to the rear side of the printer, and insert it into slot 2.
5. Slowly push the SD card into the slot until it clicks.
6. Make sure that the SD card is locked in place.
328