Service Tables; Service Program Mode; Service Mode Operation - Ricoh G-P3 Service Manual

5. Service Tables

Service Program Mode

• Before accessing the service menu, do the following:
• Confirm that there is no print data in the printer buffer (the Data In LED must not be lit or blinking).
• If there is some data in the buffer, wait until all data has been printed.
• This machine has SSP mode, which is restricted for supervisor use only. However, most of them are
also used for the factory adjustments. Do not change those SSP settings until it is advised to do so by
the technical information.

Service Mode Operation

• The Service Program Mode is for use by service representatives only so that they can properly maintain
product quality. If this mode is used by anyone other than service representatives for any reason, data
might be deleted or settings might be changed. In such case, product quality cannot be guaranteed
any more.
Entering the Service Mode
• If you switch the machine off, any jobs stored on the hard disk using the sample print and protected
print features will be deleted.
5
137