Exiting Service Mode - Ricoh G-P3 Service Manual

5. Service Tables
• Check first with the user tools to see if there are any jobs stored with these features (Menu key - Sample
Print, or Protected Print).
Method 1:
Turn the machine on while pressing the "On Line" key and "Escape" key together until "SYSTEMver x.xx/
1. Service" shows on the display.
NOTE:If you switch the machine off, any jobs stored on the hard disk using the sample print and protected
print features will be deleted.
Check first with the user tools to see if there are any jobs stored with these features (Menu key - Sample
Print, or Protected Print).
Method 2: Press the "Up/Down arrow" keys together for about 5 seconds, and then press the "OK" key.
"SYSTEMver x.xx/ 1. Service" appears on the display.
5
• The machine automatically goes off line when you enter the service mode.
Accessing the Required Program
Use the "Up/Down arrow" keys to scroll through the menu listing.
1. Service: Controller service modes
2. Engine: Engine service modes
3. End: Exit service mode
To select an item, press the "OK" key. Then the sub-menu shows.
Scroll through the sub menu items using the "
To go back to a higher level, press the "Escape" key.
Inputting a Value or Setting for a Service Program
Enter the required program mode as explained above. The setting appearing on the display is the current
setting.
Select the required setting using the "
the "OK" key is not pressed.

Exiting Service Mode

Select "End" from the service mode main menu, then press the "OK" key.
• To make the settings effective, turn the main switch off and on after exiting service mode.
138
" keys.
" keys, then press the "OK" key. The previous value remains if