Ricoh G-P3 Service Manual page 335

5. Service Tables
33 Incorrect SD card version
Module mismatch - Correct module is
34
not on the SD card)
Module mismatch – Module on SD
35
card is not for this machine
Cannot write module – Cause other
36
than E34, E35
40 Engine module download failed
5
Operation panel module download
42
failed
43 Stamp data module download failed
44 Controller module download failed
50 Electronic confirmation check failed
334
Incorrect ROM data on the SD card, or data is
corrupted.
SD update data is incorrect. Acquire the correct data
(Japan, Overseas, OEM, etc.) then install again.
SD update data is incorrect. The data on the SD card
is for another machine. Acquire correct update data
then install again.
SD update data is incorrect. The data on the SD card
is for another machine. Acquire correct update data
then install again.
Replace the update data for the module on the SD
card and try again, or replace the EGB board.
Replace the update data for the module on the SD
card and try again, or replace the LCDC.
Replace the update data for the module on the SD
card and try again, or replace the hard disks.
Replace the update data for the module on the SD
card and tray again, or replace controller board.
SD update data is incorrect. The data on the SD card
is for another machine. Acquire correct update data
then install again.