Ricoh G-P3 Service Manual page 64

6. By-pass friction pad [G]
• Pull up the edge of the by-pass friction pad (¬).
• Pull the by-pass friction pad forward. When you do this, hold down the edge where its shaft is located
(Á).
Reassembling the by-pass friction pad
1. Place the spring [H] on the projection [I] of the by-pass tray.
2. Hold down the by-pass friction pad after you put the spring on the projection of pad's reverse side
(®).
3. Release the by-pass tray friction pad when it passes through the bushing [J].
4. Pull up the shaft of the by-pass friction pad to the busing until it is clicked.
Paper Feed
3
63