Ricoh G-P3 Service Manual page 172

2111 [Manual Execut.] Manual Line Position Adjustment Execution
2111 001 Position Adjust.
2111 002 Pro. Position Adj.
2111 003 Skew Adjust.
2111 004 ID S. Adjust.
2111 005 Area.Magni.Clr.
2120 [LD Off Check]
[ID S. Display] ID Sensor Display
2143
The ID sensor assembly has three sensors: Left, Center, Right
2143 001 PWM: Left
2143 002 PWM: Center
2143 003 PWM: Right
2143 004 Avg: Left
2143 005 Avg: Center
2143 006 Avg: Right
2143 007 Max: Left
2143 008 Max: Center
2143 009 Max: Right
2143 010 Min: Left
2143 011 Min: Center
2143 012 Min: Right
2143 013 Max2: Left
2143 014 Max2: Center
2143 015 Max2: Right
2143 016 Min2: Left
Performs the line position adjustment.
Performs an approximate line position adjustment.
Performs the skew adjustment.
Tests the ID sensor.
Clears the area magnification setting.
Displays the LD off check state.
*EGB
Displays the PWM value for each sensor.
*EGB
[0 to 512 / 0 / 1/step]
*EGB
*EGB
Displays the average output from each sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB
Displays the maximum output from each sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB
Displays the minimum output from each sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB
Displays the maximum 2 output from each sensor.
*EGB
[0.00 to 5.00 / 0.00 / 0.01 volt/step]
*EGB
*EGB
Displays the maximum 2 output from each sensor.
Service Mode Table
5
171