Ricoh G-P3 Service Manual page 93

4. Troubleshooting
• This error code does not usually occur. If no problem is observed with image density and/or
development gamma, nothing needs to be done. If an image problem such as low image density is
observed, check the following points: Transfer belt/PCU/ID sensor/Toner bottle
The 8 numbers on the LCD in SP 3821 indicate the process control result for each color.
There are two numbers for each color. The numbers are shown from left to right on the display as follows:
Black, Magenta, Cyan, Yellow. For example, if process control for each color is successful: 10 (Black),
10 (Magenta), 10 (Cyan), 10 (Yellow)
4
92