Ricoh G-P3 Service Manual page 208

2756 021 T.Roll2:nd
2756 022 Separation: 2nd
[Special: [K]: LE] Transfer roller current and discharge plate voltage correction for the
leading edge area of special paper 3 in B/W mode
2771
Paper Side: 1st or 2nd
2771 003 Separation
2771 007 T.Roll 2: 1st
2771 012 T.Roll 2: 2nd
[Switch Timing] Switch timing from normal to leading edge, special paper 3
2772
(Paper Type, Edge) Paper Type -> TN: Thin, TE: Trailing Edge
2772 002 T. Roll 2: Sp3: TE
2772 003 Separation: TN: TE
[Special: [K]: TE] Transfer roller current and discharge plate voltage correction for the
trailing edge area of special paper 3 in B/W mode
2773
Paper Side: 1st or 2nd
2773 003 Separation
2773 007 T.Roll 2: 1st
2773 012 T.Roll 2: 2nd
[Switch Timing] Switch timing from normal to trailing edge, special paper 3
2774
(Paper Type, Edge) Paper Type -> TN: Thin, TE: Trailing Edge
2774 002 T. Roll 2: Sp3: TE
2774 003 Separation: TN: TE
[0 to 4 / 2.0 / 0.1 -KV/step]
Adjusts the transfer roller current for 2nd side.
*EGB
[0 to 100 / 15.0 / 0.1 -µA /step]
Adjusts the discharge plate voltage for 2nd side.
*EGB
[0 to 4 / 2.0 / 0.1 -KV/step]
*EGB [0 to 400 / 100 / 5%/step]
The value displayed on the LCD is different from
*EGB
these SP's values. For example, "20%" on the LCD
*EGB actually means 100%.
*EGB [0 to 200 / 10 / 1 mm/step]
*EGB [0 to 200 / 25 / 1 mm/step]
*EGB [0 to 400 / 100 / 5%/step]
The value displayed on the LCD is different from
*EGB
these SP's values. For example, "20%" on the LCD
*EGB actually means 100%.
*EGB [0 to 200 / 10 / 1 mm/step]
*EGB [0 to 200 / 30 / 1 mm/step]
Service Mode Table
5
207