Ricoh G-P3 Service Manual page 274

5857 [Debug Log Save]
5857 001 ON/ OFF
5857 002 Target
5857 005 Save to HDD
5857 006 Save to SD Card
5857 009 HDD to SD Latest
5857 010 HDD to SD Any
5857 011 Erase HDD Debug
5857 012 Erase SD Debug
5857 013 Dsply-SD Space
5857 014 SD to SD Latest
5857 015 SD to SD Any
5857 016 Make HDD Debug File
5857 017 Make SD Debug File
5858 [Debug Log Save: SC]
Enables Or Disables The Debug Log Saving
Function.
*CTL
[0 or 1 / 0 / 1/Step] Alphanumeric
0: OFF, 1: ON
Sets the storage location for the debug log.
*CTL [2 or 3 / 2 / 1/step]
2: HDD, 3: SD
*CTL Sets the key number of the debug log.
*CTL Sets the key number of the debug log.
Copies the most recent 4 MB of the debug log from
*CTL
the hard disk to the SD card.
Sets the key number of the debug log copied from
*CTL
the hard disk to the SD card.
*CTL Deletes the debug log from the hard disk.
*CTL Deletes the debug log from the SD card.
*CTL Shows the free space on the SD card.
Copies the most recent 4 MB of the debug log from
*CTL
an SD card to a different SD card.
Sets the key number of the debug log copied from
*CTL
an SD card to a different SD card.
*CTL Makes a log file on the HDD to save debug logs.
To save debug logs, the controller makes a log file
first, then writes data in the file. This procedure can
use much time. The user can switch off the main
power switch before the log is written in the file. To
*CTL
prevent this possible problem, you can prepare a
log file in advance. If you do this, the controller uses
less time to save logs because the log file is
prepared.
Service Mode Table
5
273