Ricoh G-P3 Service Manual page 240

3522 003 MAX [C]
3522 004 MAX [Y]
3523 [DEV.Potential] Development Potential Setting ([Color])
3523 001 MIN [K]
3523 002 MIN [M]
3523 003 MIN [C]
3523 004 MIN [Y]
3531 [M/A Target] ([Color])
3531 001 [K]
3531 002 [M]
3531 003 [C]
3531 004 [Y]
3541 [TD Setting] Toner Density Adjustment Setting
3541 001
3551 [PC SelfChk] Process Control Self-check
3551 001 Job End 1: [K]
3551 002 Job End 1: [Cl]
3551 003 Job End 2: [K]
3551 004 Job End 2: [Cl]
*EGB
[1 to 800 / 450 / 1 V/step]
*EGB
*EGB
Adjusts the minimum development bias for each
*EGB
color.
*EGB
[1 to 800 / 150 / 1 V/step]
*EGB
Adjusts the maximum toner target M/A for each
mode.
*EGB
[0.000 to 1.000 / 0.53 / 0.001 mg/step]
*EGB
*EGB [0.000 to 1.000 / 0.500 / 0.001 mg/step]
*EGB
[ 0 or 1 / 0 / -]
*EGB
0: On, 1: Off
*EGB At the end of a job, process control is done after the
interval of time that is set with SP 3555 001, if this
number of pages was printed after the previous
*EGB
process control.
[0 to 2000 / 450 / 1 page/step]
*EGB At the end of a job, process control is done
immediately, if this number of pages was printed
after the previous process control.
*EGB
[0 to 2000 / 450 / 1 page/step]
Service Mode Table
5
239