Table of Contents
Advertisement
Enabling RIP
RIP is disabled by default. Use the
example:
-> ip rip admin-state enable
Use the ip rip admin-state disable command to disable RIP routing on the switch. Use the
command to display the current RIP status.
Creating a RIP Interface
You must create a RIP interface on a VLAN's IP router interface to enable RIP routing. Enter the
interface
command followed by the name of the VLAN router port. For example, to create a RIP inter-
face on a router port with a name of rip-1 you would enter:
-> ip rip interface rip-1
Use the no ip rip interface command to delete a RIP interface. Use the
to display configuration and error information for a RIP interface.
Note. You can create a RIP interface even if an IP router interface has not been configured. However, RIP
does not function unless a RIP interface is created and enabled on an IP router interface. See
"Configuring VLANs,"
Enabling a RIP Interface
Once you have created a RIP interface, you must enable it to enable RIP routing. Use the
admin-state
command followed by the interface IP address to enable a RIP interface. For example, to
enable RIP routing on a RIP interface rip-1 you would enter:
-> ip rip interface rip-1 admin-state enable
To disable an RIP interface, use the disable keyword with the ip rip interface admin-state command. For
example to disable RIP routing on a RIP interface rip-1 you would enter:
-> ip rip interface rip-1 admin-state disable
Configuring the RIP Interface Send Option
The RIP Send option defines the type(s) of RIP packets that the interface sends. Using this command
overrides RIP default behavior. Other devices must be able to interpret the information provided by this
command or routing information is not properly exchanged between the switch and other devices on the
network.
Use the
ip rip interface send-version
Enter the IP address of the RIP interface, and then enter a Send option. For example, to configure a RIP
interface rip-1 to send only RIPv1 packets you would enter:
-> ip rip interface rip-1 send-version v1
The Send options are:
•
v1. Only RIPv1 packets is sent by the switch.
OmniSwitch AOS Release 7 Network Configuration Guide
ip rip admin-state
and
Chapter 11, "Configuring IP,"
command to configure an individual RIP interface Send option.
command to enable RIP routing on the switch. For
show ip rip interface
for more information.
March 2011
show ip rip
ip rip
command
Chapter 4,
ip rip interface
page 157
Advertisement
Table of Contents
