At-Ar720 Dip Switch Settings - Allied Telesis AR Series Hardware Reference Manual

94
Figure 61: Location of main components, jumpers and DIP switch on the AT-AR720 base CPU card.
SLIDE-IN BAY 0
PIC SLOT
LITHIUM BATTERY
DO NOT
DISPOSE IN FIRE
RUN CLEAR
POWER SYSTEM
the stick down onto the retaining latches and ensure the latches hold the
stick firmly in place.
4. Replace the router lid and the power cord.
Secure the router's lid. If you disconnected an RPS supply, reconnect it
now.

AT-AR720 Dip Switch Settings

A DIP switch is used to change functional characteristics of the base CPU card.
Figure 61 on page 94 shows the DIP switch's location on the AT-AR720's base
CPU card. DIP switch functions are shown in Table 36 on page 95.
All DIP switches should be left in the factory default positions unless advised
by your distributor or reseller that they need to be changed. Jumpers should
only be replaced by authorised service personnel. Unauthorised opening of the
router lid may cause danger of injury from electric shock, damage to the router,
and invalidation of the product warranty.
SLIDE-IN BAY 1
PIC SLOT
FLASH SIMM
BOOT EPROM 1
BOOT EPROM 0
SECURITY
RJ45 RJ45 RJ45
Tx Col 100
Rx Lnk FD
PORT 0 PORT 1
ETHERNET 0
MAC CARD SLOT
S/N
AR Router
Clr Err D Act
Sec Sys Run Pwr
DIP SW
720CPU
C613-03031-01 REV C