Bgp Default Ipv4-Unicast - Allied Telesis AT-AR3050S Command Reference Manual

BGP BGP4+ C
AND OMMANDS
4-
BGP DEFAULT IPV UNICAST

bgp default ipv4-unicast

Overview This command configures BGP defaults and activates IPv4-unicast for a peer by
default. This affects BGP global configuration. By default, BGP exchanges IPv4
prefixes with a peer.
The no variant of this command disables this function. The BGP routing process
will no longer exchange IPv4 addressing information with BGP neighbor routers.
Note that disabling the exchange of IPv4 prefixes will also enable an IPv6 only
BGP4+ network.
bgp default ipv4-unicast
Syntax
no bgp default ipv4-unicast
Default This is enabled by default.
Mode Router Configuration
Usage Use the negated form of this command to enable an IPv6 only BGP4+ network.
Examples awplus#
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
C613-50077-01 REV A
configure terminal
router bgp 100
bgp default ipv4-unicast
configure terminal
router bgp 100
no bgp default ipv4-unicast
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
965