Power Inline Usage-Threshold; Power Inline Traps Enable - Allied Telesis AT-8000S Cli Reference Manual

Allied Telesyn AT-8000S Switch
CLI Reference Guide
Example
The following example configures the device connected to Ethernet interface 1/e1 as a high-priority powered
device.
Console(config)# interface ethernet 1/e1
Console(config-if)# power inline priority high

power inline usage-threshold

The power inline usage-threshold Global Configuration mode command configures the threshold for initiating
inline power usage alarms. To return to the default configuration, use the no form of this command.
Syntax
power inline usage-threshold percentage
no power inline usage-threshold
Parameters
•
percentage—Specifies the threshold as a percentage to compare measured power. (Range: 1-99)
Default Configuration
The default threshold is 95 percent.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the power usage threshold for which alarms are sent to 80%.
Console(config)# power inline usage-threshold 80

power inline traps enable

The power inline traps enable Global Configuration mode command enables inline power traps. To disable inline
power traps, use the no form of this command.
Syntax
power inline traps enable
no power inline traps
Default Configuration
Inline power traps are disabled.
Page 132