Chapter 15.Power Over Ethernet Commands; Power Inline; Power Inline Powered-Device - Allied Telesis AT-8000S Cli Reference Manual
Layer 2 ethernet switch
Hide thumbs
Also See for AT-8000S:
- Cli user's manual (403 pages) ,
- Cli reference manual (334 pages) ,
- User manual (249 pages)
Table of Contents
Advertisement
Allied Telesyn AT-8000S Switch
CLI Reference Guide
Chapter 15.Power over Ethernet Commands
Note
The PoE commands are operational in the AT-8000S/24, AT-8000S/24POE, AT-8000S/48 and AT-
8000S/48POE devices.
power inline
The port inline Interface Configuration (Ethernet) mode command configures the administrative mode of inline
power on an interface.
Syntax
power inline {auto | never}
Parameters
•
auto—Enables the device discovery protocol and, if found, supplies power to the device.
•
never—Disables the device discovery protocol and stops supplying power to the device.
Default Configuration
The device discovery protocol is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables powered device discovery protocol on port 1/e1, so that power will be supplied to
a discovered device.
Console(config)# interface ethernet 1/e1
Console(config-if)# power inline auto
power inline powered-device
The power inline powered-device Interface Configuration (Ethernet) mode command adds a comment or
description of the powered device type to enable the user to remember what is attached to the interface. To
remove the description, use the no form of this command.
Syntax
power inline powered-device pd-type
Page 130
Advertisement
Table of Contents
