PROCESSOR DRUM
Prerequisites:
To Remove:
DRUM DRIVE BELT
2G0947 - 31JAN08
Remove:
•
"LEFT PANEL"
•
"RIGHT PANEL"
TIE WRAP
CONNECTOR
1. Remove:
•
2 SCREWS
•
RIGID DUCT
2. Cut the TIE WRAP that secures the DRUM CABLE to the PROCESSOR
CONTROL BOARD.
3. Disconnect the CONNECTOR from the PROCESSOR CONTROL
BOARD.
4. Disengage the DRUM DRIVE BELT from the DRUM PULLEY.
Adjustments and Replacements
DRUM PULLEY
DRUM CABLE
PROCESSOR
CONTROL BOARD
RIGID DUCT
2 SCREWS
3-27