Condition Code: 21-119 Or - Kodak DryView 5800 Service Manual

Condition Code: 21-119 or 23-119

Web Portal Message
xxxxx Supply: Internal
Hardware Failure
2G0947 - 31JAN08
Log Message
xxxxx Supply: Film contact
sensor (S2x) failed to confirm
that the pickup arm assembly
lowered and contacted the film
Description
This error occurs only while attempting to pick up a film or checking for film in
the FILM TRAY. After the PICKUP HOME SENSOR (S1x) confirmed that the
PICKUP had left its home position, the FILM CONTACT SENSOR (S2x) did
not confirm that film contact was made. This error can also occur when the
FILM CONTACT SENSOR was active when the PICKUP was at home, or
when the FILM CONTACT SENSOR is stuck on. The most likely cause of the
error is a failed FILM CONTACT SENSOR (S2x). The error is cleared when a
FILM TRAY is re-inserted after being removed.
System Impact
One or more feed magazine(s) is unable to print. The spooler is still able to
accept and queue jobs and continue printing from any other available supply
tray.
User Action
1. Cover the FILM TRAY with the FILM SAVER. Remove the tray from
the IMAGER.
2. Re-insert the FILM TRAY and remove the FILM SAVER.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
1. De-energize then energize the LASER IMAGER.
2. Do the following:
Check:
FILM TRAY
For a film jam.
CONNECTORS and CABLES
PICKUP HOME SENSOR
DICOM Message
FILM TRANS ERR
If an existing problem:
Install a new FILM TRAY.
Remove films.
Seat all CONNECTORS.
Install a new SENSOR (see Adjustments
and Replacements, "SENSOR, PICKUP
HOME - UPPER (S1U) and LOWER
(S1L)" on page 3-81).
Diagnostics
Severity
1-Alert
5-63