Installation Instructions
Logging Onto the SERVICE TOOL
Logging Off the SERVICE TOOL
2-4
IMPORTANT
:
•
You must have the SECURE LINK CLIENT SOFTWARE, Version 2.3
or higher and the Service WebLink Client Software, Version 3.1.0.5 or
higher installed and configured on your LAPTOP COMPUTER. Both of
these are located on the Intranet at:
http://know.us.kodak.com/audience_fe001/stage/global/en/Health-Medica
l/Service_Systems/index.shtml
•
You will not be able to log on until 3 or 4 minutes after you have
energized the IMAGER.
1. Connect the LAPTOP COMPUTER to the IMAGER (see
the LAPTOP COMPUTER to the IMAGER" on page
2. Energize the LAPTOP COMPUTER.
3. Select Start>Programs>Kodak>SecureLink.
4. Type your password.
5. Click [OK].
6. Type the IP address of the Service Port: 192.168.000.1
7. Check that the Port is set to: 443
8. Click [Connect].
9. Select Start>Programs>Kodak>Service WebLink.
The main menu of the SERVICE TOOL displays.
1. In the right corner of the SERVICE TOOL, click [Log Off].
2. At the Kodak Service WebLink screen, click [Log Off].
3. Close the WebLink Client Software.
4. At the Secure Link screen:
•
click [Disconnect]
•
close the screen
5. Disconnect the LAPTOP COMPUTER from the IMAGER.
6. If you are finished with the SERVICE TOOL, install the RIGHT PANEL.
"Connecting
2-2).
2G0947 - 31JAN08