Condition Code: 21-122 Or - Kodak DryView 5800 Service Manual

Condition Code: 21-122 or 23-122

Web Portal Message
xxxxx Supply: Internal
Hardware Failure
2G0947 - 31JAN08
Log Message
xxxxx Supply: Film Separation
sensor (S3x) failed to confirm
film separation.
Description
This error occurs only while attempting to pick up a film. The PICKUP CUPS
were lowered onto the film and the suction was applied, but the FILM
SEPARATED SENSOR (S3x) did not actuate. The error is cleared when a
FILM TRAY is re-inserted after being removed.
System Impact
One or more feed magazine(s) is unable to print. The spooler is still able to
accept and queue jobs and continue printing from any other available supply
tray.
User Action
1. Cover the FILM TRAY with the FILM SAVER. Remove the FILM
TRAY from the IMAGER.
2. Take the FILM TRAY to a dark room and remove the FILM SAVER.
Verify that the film is lying flat. Replace the FILM SAVER.
3. Re-insert the FILM TRAY and remove the FILM SAVER.
4. If this error repeats, try a new film pack.
5. If the error persists, call for service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
1. De-energize then energize the LASER IMAGER.
2. Do the following:
Check:
FILM TRAY
For a film jam.
CONNECTORS and CABLES
FILM SEPARATED SENSOR
DICOM Message
FILM TRANS ERR
If an existing problem:
Install a new FILM TRAY.
Remove films.
Seat all CONNECTORS.
Install a new SENSOR (see Adjustments
and Replacements, "SENSOR, FILM
SEPARATED - UPPER (S3U) and
LOWER (S3L)" on page
Diagnostics
Severity
1-Alert
3-83).
5-65