Kodak DryView 5800 Service Manual page 155

Film Supply
State
Manual Mode • Attention LED on
• Status code: 21002 (upper),
23002 (lower)
• Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
No FILM • Unlock Button/LED on
TRAY • Cal Button/LED off
• Supply info area displays icon
for this state
Ready • Unlock Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
Requires • Attention LED on
Calibration • Status code: 21001 (upper),
23001 (lower)
• Unlock button LED on
• Cal button LED off
• Supply info area displays film
type, size, and count
Supply Open • Ready LED off
• Unlock Button/LED off
• Cal Button/LED off
• Supply info area blank
Unlock Pending • Ready LED off (or blinking if
active print)
• Cal Button/LED off (or
blinking if active calibration)
• Unlock Button/LED blinking
• If the FILM TRAY requires a
cover, the status code is:
Status code: 21002 (upper),
23002 (lower)
2G0947 - 31JAN08
Table 5-3: Film Supply Status Messages (Cont'd)
Local Panel Display
Web Portal
Display
The film in this FILM SUPPLY does
not meet AIQC standards. However,
the user has selected "Manual
Mode", so it will be used as if it is
"Ready".
Invalid FILM There is a FILM TRAY in the FILM
TRAY SUPPLY but it does not contain a
LINER/RF TAG.
normal tray info The FILM SUPPLY is ready for use.
Requires The FILM TRAY must be calibrated
Calibration before the IMAGER can print from
it.
No FILM TRAY There is no FILM TRAY in the
FILM SUPPLY.
Unlock An "Unlock" has been requested but
Requested has not started because of one of the
following:
• films are still moving through the
IMAGER
• the FILM TRAY contains film
but has not been covered with a
FILM SAVER
Once the conditions for unlock are
met, the supply state will change to
"No FILM TRAY".
Diagnostics
Description
5-7