Kodak DryView 5800 Service Manual page 117

To Install:
2G0947 - 31JAN08
2. Remove:
•
NUT
•
VACUUM PUMP
•
ADHESIVE FOAM PAD
•
LOOP CLAMP
1. Use ALCOHOL WIPES to clean the adhesive from the VACUUM
PUMP installation area.
2. Place the LOOP CLAMP on the new VACUUM PUMP.
3. Align the VACUUM PUMP with the new ADHESIVE FOAM PAD on
the base.
4. Place the ends of the LOOP CLAMP on the BOLT.
5. Remove the paper backing from the ADHESIVE FOAM PAD.
6. Press down to adhere the ADHESIVE FOAM PAD and VACUUM
PUMP.
7. Install:
•
NUT
•
CONNECTOR
•
TUBING
Adjustments and Replacements
3-75