Adjustments and Replacements
To Adjust
3-10
Virtual notch
Correct
2 mm (0.08 in.) half-tone density border
5. Check for a 2 mm (0.08 in.) half-tone density at the leading edge of the
film with no transparent area appearing.
1. Select Configuration>Hardware>Optics.
2. Observe the number displayed in the "Page Start Delay" window.
NOTE:
•
When viewing the film on a LIGHT BOX, the notch on the film must
be in the upper right.
•
If the half-tone density, as viewed on a LIGHT BOX, is too narrow,
the number must be increased.
•
If the half-tone density, as viewed on a LIGHT BOX, is too wide, the
number must be decreased.
Printing above
half-tone border
Virtual notch
Incorrect
2G0947 - 31JAN08