Kodak DryView 5800 Service Manual page 229

Condition Code: 26-326
Web Portal Message
Film Jam in Area 2 or 3
2G0947 - 31JAN08
Log Message
Film Jam Exiting Exposure
Transport: SOP sensor (S8)
failed to detect film trailing
edge.
Description
This error occurs if the trailing edge is not detected at the START OF PAGE
(SOP) SENSOR (S8) after the film has entered the EXPOSURE TRANSPORT
area. The error is cleared when the TOP COVER is opened then closed. When
this error occurs, the PROCESSOR stops rotating and the HEATER is turned
off. All films in the printer will be marked bad and reprinted automatically.
System Impact
The printer is unable to print films. The spooler is still able to accept and queue
jobs but new films will not be initiated. Films downstream of the affected
subsystem will be completed. All other films will be reprinted.
User Action
1. Open the IMAGER TOP COVER.
2. Unlatch and open the PROCESSOR COVER.
3. Carefully remove any films found in the PROCESSOR.
4. Close and latch the PROCESSOR COVER.
5. Close the TOP COVER. If film was not previously removed, the
misplaced films will emerge from the IMAGER within 2 minutes.
FE Action
1. Clear the jam (see
page 5-111).
DICOM Message
FILM JAM
"Film Jam - Error Codes 26-326 or 26-543" on
Diagnostics
Severity
1-Alert
5-81