Kodak DryView 5800 Service Manual page 50

Adjustments and Replacements
To Adjust
Decrease the left border on the test print, do:
a. Click [Modify] and increase the number in the
"Index Delay" window by 50. This will decrease the
left border by 2 mm (0.08 in.).
b. Click [Save].
c. Make another Test Print and check the index delay
area again.
d. Do Step a through Step c until the left border
matches the right border.
3-8
1. Select Configuration>Hardware>Optics.
2. Observe the number displayed in the "Index Delay" window.
NOTE:
There are 2 Index Delay adjustments depending on the width of the
film:
•
When viewing the film on a LIGHT BOX, the notch on the film must
be in the upper right.
•
If the left border, as viewed on a LIGHT BOX, is too narrow, the
number must be decreased.
•
If the left border, as viewed on a LIGHT BOX, is too wide, the
number must be increased.
3. To:
Increase the left border on the test print, do:
a. Click [Modify] and decrease the number in the
b. Click [Save].
c. Make another Test Print and check the index delay
d. Do Step a through Step c until the left border
"Index Delay" window by 50. This will increase the
left border by 2 mm (0.08 in.).
area again.
matches the right border.
2G0947 - 31JAN08