Condition Code: 21-125 Or - Kodak DryView 5800 Service Manual

Condition Code: 21-125 or 23-125

Web Portal Message
xxxxx Supply: Internal
Hardware Failure
2G0947 - 31JAN08
Log Message
xxxxx Supply: Feed Roller
Sensor (S4) failed to detect feed
roller open/closed position.
Description
This error occurs if the FEED ROLLER NIP SENSOR (S4) does not change
from blocked to unblocked when opening or from unblocked to blocked when
closing. Most likely cause is the FEED ROLLER NIP OPEN/CLOSE MOTOR
(M1) did not turn or the SENSOR did not detect the motion. The error is cleared
when a FILM TRAY is re-inserted after being removed.
System Impact
One or more feed magazine(s) is unable to print. The spooler is still able to
accept and queue jobs and continue printing from any other available supply
tray.
User Action
1. Cover the FILM TRAY with the FILM SAVER. Remove the tray from
the IMAGER.
2. Re-insert the FILM TRAY and remove the FILM SAVER.
3. If the error persists, call for service.
FE Action
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
Do the actions below in sequence. If an action provides a resolution, do not
continue with the other actions.
1. De-energize then energize the LASER IMAGER.
2. Do the following:
Check:
CONNECTORS and CABLES
FEED ROLLER NIP SENSOR
FEED ROLLER NIP
OPEN/CLOSE MOTOR
3. Install a new.
DICOM Message
FILM TRANS ERR
If an existing problem:
Seat all CONNECTORS.
Install a new SENSOR.
Install a new MOTOR (see Adjustments
and Replacements, "MOTOR, FEED
ROLLER NIP OPEN/CLOSE (M1)" on
page 3-53).
Diagnostics
Severity
1-Alert
5-67