Kodak DryView 5800 Service Manual page 88

Adjustments and Replacements
INTERLOCK
SWITCH
Left side of
IMAGER
E-RING
IDLER
SHAFT
To Install:
3-46
ROLLERS
3 BELTS
4. Slide the 3 BELTS off the ROLLERS.
5. Remove the E-RING from the inside left of the IDLER SHAFT.
NOTE:
For the upper IDLER SHAFT you should remove the LEFT PANEL
INTERLOCK SWITCH (see
RIGHT PANELS" on page
6. Using a straight slot SCREWDRIVER, unscrew the IDLER SHAFT from
the left side.
7. Push the IDLER SHAFT to the left to disengage it from the right side of
the FRAME, then to the left to remove it.
8. Remove:
•
6 E-RINGS
•
3 ROLLERS
1. Reverse the steps in the removal procedure.
"SWITCH, INTERLOCK - LEFT and
3-19).
6 E-RINGS
3 ROLLERS
IDLER SHAFT
2G0947 - 31JAN08