Kodak DryView 5800 Service Manual page 154

Diagnostics
Printer
Local Panel Display
Status
Warming • Ready LED off
• Warming LED on
• Number of minutes
until warm shown
Film Supply Status Messages
Film Supply
State
Calibrating • Attention LED on
• Status code: 21001 (upper),
23001 (lower)
• Unlock Button/LED on
• Cal Button/LED off
• Supply info area displays film
type, size, and count
Failed • Attention LED on
• Status code: 21000 (upper),
23000 (lower)
• Unlock Button/LED on
• Cal Button/LED flashing
• Supply info area displays icon
for this state
Film Covered • Attention LED on
• Status code: 21003 (upper),
23003 (lower)
FILM TRAY • Unlock Button/LED on
Empty • Cal Button/LED off
• Supply info area displays film
type, size, and count
5-6
Table 5-2: MCS Printer Status Messages (Cont'd)
Web Portal
Display
Warming=xx
The following table describes how the LOCAL PANEL and Web Portal indicate
film supply status to the user.
Table 5-3: Film Supply Status Messages
Local Panel Display
DICOM Status
WARNING /
PROC INIT
Web Portal
Display
Calibrating A calibration is in progress for this
FILM TRAY.
Failed An error has occurred that affects
normal operation. This FILM
SUPPLY is currently not usable and
requires user intervention.
Film is Covered The FILM BAG or FILM SAVER is
still on and must be removed before
the FILM TRAY can be used.
Empty and/or There is a FILM TRAY in the FILM
sheet count of 0 SUPPLY; it contains a liner/RF tag
and the sheet count is 0.
Description
The PROCESSOR is
warming up and will not be
ready to print for xx
minutes.
Description
2G0947 - 31JAN08