Film Path Microcontroller Board - Kodak DryView 5800 Service Manual

FILM PATH MICROCONTROLLER BOARD

Prerequisites:
To Remove:
To Install:
2G0947 - 31JAN08
1. Do "Making a Configuration Backup" on page
2. Remove the "RIGHT
IMPORTANT
:
When installing CIRCUIT BOARDS, always use a WRIST STRAP to prevent
damage from electrostatic discharge.
MICROCONTROLLER
1. Disconnect the CONNECTORS.
2. Remove:
•
3 SCREWS
•
FILM PATH MICROCONTROLLER BOARD
1. Reverse the steps in the removal procedure.
NOTE:
If necessary, do
PANEL".
FILM PATH
BOARD
"Restoring the Configuration" on page
Adjustments and Replacements
8-1.
CONNECTORS
3 SCREWS
8-2.
3-91