Selecting Film - Kodak Ektascan 2180 User Manual

User's Manual

Selecting Film

Overview
The [Select Film] key on the Keypad allows you to select or change the film size or type
that is used by the imaging device. The Control Terminal or Auxiliary Keypad may be
used to select film for autofilming imaging devices.
There are two film types (blue base and clear base), and four film sizes for the 2180
Laser Printer:
• 8 x 10 inch
• 11 x 14 inch
• 35 x 35 cm
• 35 x 43 cm
Note
The Supply Magazines in your Printer are set up and labeled for the film sizes and types
that will be used at your site. If your site changes the film sizes or types that are used,
contact your Service Representative or see Appendix A of this manual for instructions
to change the Supply Magazines setup.
Important
You can select a film size and type even if it isn't currently in the Printer. The films will
be held in the Image Buffer until the appropriate film size and type are loaded and set up
in the Printer.
The Supply Magazine can hold 100 sheets of roomlight-load film and 103 sheets of
darkroom load film.
3–4 5B9615