Thermo Scientific APEX 100 User Manual page 358

30034 n/a 1
30035 n/a 1
30036 41047 1 16389
30037 41048 2 16390
30039 41050 2 16391
30041 41052 2 16392
30043 41054 2 16393
30045 41056 2 16394
30047 41058 1 16395
30048 41059 9 16396
30057 41068 1 16397
Thermo Scientific APEX User's Guide
n/a RO bitmap M
n/a RO bitmap M
5 R/W enum P
6 R/W float P
7 R/W float
8 R/W float P
9 R/W float P
10 R/W float P
11 R/W enum P
12 R/W string P
13 R/W enum P
Fault Status
Alarm Status
Product Speed Encoder
Product Speed
Speed Filter Speed
Phase Angle
Phase Tracking Limit
Phase Tracking Fault Limit
Phase Tracking
Product Name
Detection Type
Page 358
bit 0: Reject Confirmation Error
bit 1: Reject Bin Full
bit 2: Infeed Photo-eye blocked
bit 3: Detection with a stopped belt
bit 4: Detection outside of a pack
bit 5: Phase tracking limit exceeded
bit 6: Search Head Problem
bit 7: QAT timeout
bit 8: QAT failed
bit 9: AuditCheck timeout
bit 10: AuditCheck failed
bit 11: NVRAM battery low
bit 12: Excess Rejects
bit 13: Memory Corruption
bits 14-31: <reserved> bit set if fault active
Parameters are the same as Fault Status
0 = Disabled
1 = Enabled
Note: A Speed Learn must be performed for encoder
to provide valid speed. This is done by enabling the
encoder using the controls at the front panel.
0.1 to 999.0 m/min
Note: Speed Encoder must be disabled to change
speed remotely.
0.1 to 999.0 Hz
Note: If Speed Filter Ratio is Learned, updating
Product Speed will update Speed Filter.
-45.00 to 135.00 degrees
0.00 to 135.00 degrees
0.00 to 135.00 degrees
0 = Disabled
1 = Enabled
18 chars in length
0 = Amplitude
1 = Multi-Zone