Setting Engineer And Operator Passwords; Retrieving A Forgotten Password - Thermo Scientific APEX 100 User Manual

Setting Engineer and Operator Passwords

"Engineer," "Operator 1," and "Operator 2" passwords are set in the same way as
described above for supervisors.
1) Go to the screen shown in step 7 in the "Entering a Supervisor Password" section
above.
2) Highlight the level (Level 1, Level 2, or Level 3) for which you want to enter a
password.
3) Press the Go button and the keyboard screen reappears.
4) Key in a new password for the level. You must key in the new password twice, as
follows.
a. Key in the new password, navigate to the exit-and-save key, and press the
Go button. (The display panel still shows the keyboard screen, but a second
key icon has appeared in the entry field.)
b. Key in the new password again, navigate to the exit-and-save key, and press
the Go button.
5) Now that you (as supervisor) have set up passwords for all personnel using the
detector, you need to log out.
6) See page 256 for log-out instructions.

Retrieving a Forgotten Password

This can only be done by a supervisor.
1) Log in and navigate to the screen below.
Forgotten Password?
(continued...)
Thermo Scientific APEX User's Guide Page 253