2) Press the Go button, and an input screen appears.
IP Address
3) Use the navigation buttons to enter the IP address, then press the Go button to close
the input screen. The flashing asterisk indicates the IP address has been changed.
IP Address
4) If you are finished, go to the "Saving Your TCP/IP Settings" section—this is
important! Or continue the set-up as described below.
Changing the Subnet-Mask Address
In order to change the subnet-mask address, DHCP must be set to "off."
1) Make sure the subnet mask function is highlighted.
2) Press the Go button, and an input screen appears.
3) Use the navigation buttons to enter the subnet-mask address, then press the Go
button to close the input screen. The flashing asterisk indicates the subnet-mask
address has been changed.
Subnet Mask
Thermo Scientific APEX User's Guide
Page 331