Thermo Scientific APEX 100 User Manual page 190

Assigning Signals to Channels
In this example you are going to assign the X-input signal to Channel 1 and the R-input
signal to Channel 2. However, as you become more familiar with the oscilloscope, you
can assign a variety of signals to Channels 1 and 2.
1) Make sure page 1 of the scope-configuration menu is displayed and the analog
channel-1 menu is highlighted.
Scope Configuration 1/2
2) Press the right-navigation button to scroll through the analog channel-1 menu
options, then use the left-navigation button to scroll back through the options.
Highlight the "X:INPUT" option, which assigns the X-input signal to the oscilloscope's
analog Channel 1.
3) Press the down-navigation button to exit the analog channel-1 menu and save your
setting. The analog channel 2 menu should now be highlighted, as shown below.
Scope Configuration 1/2
4) Follow the instructions in step 2 to assign the R-input signal ("R:INPUT") to the
oscilloscope's analog Channel 2.
5) Press the Back button to exit the scope-configuration menu and return to the start-
up oscilloscope screen.
Further Exploring the Scope-Configuration Menu
Now that you know how to navigate the scope-configuration menu, we'll leave you to
explore the remaining functions on your own. However, if you need additional help
understanding or using any of the oscilloscope's functions, please contact Thermo Fisher
Scientific—as described in the "Contacting Thermo Fisher Scientific" section at the end of
the manual.
Page 190 Thermo Scientific APEX User's Guide