Thermo Scientific APEX 100 User Manual page 233

3) Press the Go button the output set-up menu appears.
Output Setup
Description of the Icons
The icons in the output set-up menu are as follows.
Output Icon
1
2
3
4
5
6
What the Output Set-Up Screen Is Telling You
In the output set-up screen above, Outputs 1–6 are listed at the top of the screen
(where all polarities are currently set to plus), and below are shown the default logical
(software-based) assignments for these output devices. Because all of these
assignments (polarity/device) are logical, they can be changed by you, the user. How
you do this is described in the following section.
Thermo Scientific APEX User's Guide
Logical (software) output-device assignments
Main (Reject 1) device
(Used in conveyor applications)
AuditCheck reject device
(Used in conveyor applications)
Quality-Assurance Test reject device
(Used mostly in conveyor applications)
Warning device
(This device is activated when one of the detector's functions
issues a warning. Usually connected to a light.)
Alarm device
(This device is activated when one of the detector's functions
issues an alarm. Usually connected to a buzzer.)
Fault device
(This device is activated when one of the detector's functions
issues a fault. Usually connected to a shut-off switch.)
Page 233