Undoing The Need For Passwords - Thermo Scientific APEX 100 User Manual

2) Press the Go button and a screen similar to the one below appears.
Contact Thermo to retrieve passwords
3) Make a note of the information in the screen. Contact Thermo Fisher Scientific's
technical-support personnel—as described in the "Contacting Thermo Fisher
Scientific" section at the end of the manual.

Undoing the Need for Passwords

Once you have set passwords but decide not to use them (for all personnel—supervisors,
engineers, and operators), you can undo the need for passwords (and, thus, the need
for any log-in procedures) as follows.
1) Log in as a supervisor and navigate to the screen shown below, which you can reach
by following steps 1–6 in the "Entering a Supervisor Password" section above.
Activate Passwords
2) Press the Go button and the check mark in the passwords menu changes to an X.
Passwords are now no longer required, and all personnel have full access to all of the
detector's functions.
3) Press the Back button to exit the menu. The X next to the key icon tells you
passwords are no longer required.
Security Level
Page 254 Thermo Scientific APEX User's Guide