Printer Set-Up; Activating An End-Of-Day Print-Out - Thermo Scientific APEX 100 User Manual

Printer Set-Up—Page 2
This menu allows you to set up end-of-day, reject, and power-up print-outs.
1) To reach page 1 of the printer set-up menu (shown below), follow steps 1–6 in the
"Navigating to the Printer Set-Up Menu" section above (pages 239–40).
Printer Setup Page 1
2) Press the down-navigation button and page 2 of the printer set-up menu appears.
Printer Setup Page 2

Activating an End-of-Day Print-Out

This function allows you to print an end-of-day report. For this function to work, you
must first have done the following.
• Activated the printer (described above on page 241).
• Set the detector's time and date function (see page 176).
Activate End of Day Printout
1) Make sure the end-of-day function is highlighted.
2) Press the Go button and the X is replaced by a check mark. End-of-day printing is
now activated.
3) Press the Back button to exit the function.
Thermo Scientific APEX User's Guide Page 245