Set-Up Check List for Conveyor
Applications
This section lists the parameters you have already set (by following the instructions from
the start of the "Setting Up Conveyor Applications" section up to this point in the
manual). This section also lists additional parameters you may want to set up to get
your particular conveyor application running to your satisfaction.
Parameters You Have Already Set Up
Listed below are the parameters you have already set up for a typical conveyor
application.
Product Parameters
•
Product name
•
Pack length
•
No-pack distance
•
Pack gap
Conveyor and Photo-Eye Parameters
•
Conveyor belt-speed
•
Photo-eye-to-detector distance
•
Polarity of the photo-eye input
•
Photo registration for product rejects
Reject Parameters
•
Distance to the reject device
•
Signal duration for the reject device
Contaminant-Detection Parameters (Set by the Detector's Calibrate Functions)
•
X and R noise thresholds
•
Speed-filter setting
•
Detect level
•
Phase-angle setting
Thermo Scientific APEX User's Guide
Page 61